Rekord trigger mod

Basically making a new trigger blade, but using bearings for the pivot to eliminate as much play as possible and to be able to adjust the stages by using set screws in place of the roller pins. I might even alter the pivot point forward in the housing, which will change the geometry making the second stage much smoother and lighter while remaining safe.

I hope I actually finish it too. here goes.

Got some 5 x 2.5 x 2mm bearings and 2mm axle

Remove trigger unit. Note heaps of dirty grease on sears. I will polish and clean these once I've done the trigger blade.

I drill the 5mm hole for the bearing. I will work off this point as I can put the original trigger on and off as I go as a reference.

Then comes the cutting. This is just std aluminium so I can remove the rough stuff, but I just don't have any other way of cutting out the shape.

I plan to make it set back a bit more and straighter than the original.

That was it for tonight. Thought I would stop there before I either cocked it up or realised I had already made a mistake.