.22 barrel

hi Paul,i have approx 300mm of crosman 22 barrel here mate,left over from pcp revolver project if of any use to u,let me know eh,swap u for approx same length of 177 barrel if u got some.no rush for some 177 barrel will send u 22 barrel if suits your purpose and sort out 177 barrel later.

barrel 320mm long and is the breech end mate and full factory diameter,so be good for your project,make me offer,as cant remember what cost.

The barrel diameter is 10 mm, with that waist section 8 mm diameter, starting 10 mm from the breech face.
That is the breech end in the picture. I wouldn't be able to turn down the barrel with my baby lathe, so do you reckon you could do it for me and I will pay you on top of the cost of the barrel?



Edited by Pauly5 - 10 Sep 2020 at 12:26pm

sent you a PM mate,had trouble getting on forum for some reason had been shut out,so had get new password lol.

Edited by Pauly5 - 12 Sep 2020 at 4:20am

does your factory barrel have any sort of pellet chamber at rear ???,do you want it cut to 250mm can leave longer if you want mate.

all good mate,will just releave rifling a little so you can seat pellet etc,can leave barrel as long as possible and you cal trim and crown yourself.