Valve mod - pcp pistol

yes. ive mounted the red dot directly. i made the dove tail plate, but didnt use it.

It would have been around 1800 - 2000 psi

Looking good pauly. Just wondering if your going to make a separate plate for mounting plate would it be worth making the center narrower at the width of a scope mount, then angle grinding at the bottom of said recess so a dovetail scope mount can be used. Same for front except probably could be just scope mount width.
Maybe place for ghost ring at back, assuming you can put a post of some sort on barrel.
Should put up your work to air valve on crosman you recently did.
Being that looks like a 13xx trigger platform, are you going to alter the trigger sears?
Ive been toying with the idea of (but haven't done yet) of taking a mm off the face of the sear that ingauges the hammer, creating a step where the last mm or two of travel has a slight click into place as the hammer "drops" into place for the final part of travel. Sort of a hair trigger set for what is otherwise a reasonably unfeeling trigger system.


Edited by kruzaroad - Yesterday at 10:56am

I have a dovetail cutter here i brought many years ago for cutting groves in for mounts. Happy to send it to you to use if you need it.