FX Cyclone pellet feed issue

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I changed from .177 JSB Exact Diablo (8.44g) to H&N Baracudas (10.65) and immediately found pellets mag or pellet seating jamming often. Mag seems to seat fine only when cocking is there the issue.

Wiggling the cocking lever at the same time as the mag can fix the issue, but sometimes I need to pull mag shaft and cocking back and wiggle the mag to get it out then re-fit.

This is recurring on each mag.

I removed and lubed the mag O ring and mag and found zero issues with JSB, but the H&N Baras will load but with extra force required - pre-lube they did not want to load at all.

I note all pellets looked and loaded fine when loaded into the mag.

Has anyone else found issues with loading high quality pellets of different sizes?   

I presume my used Cyclone has done a bit of work given previous owners used it for culling, professionally I think...could this indicate a service and maybe replacement of some parts is over-due?

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
JasonEdward Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: 21 Sep 2024 Location: Waihi Status: Offline Posts: 98	Post Options Post Reply Quote JasonEdward Report Post Thanks(0) Quote Reply Topic: FX Cyclone pellet feed issue Posted: 21 hours 55 minutes ago at 12:05pm
	I changed from .177 JSB Exact Diablo (8.44g) to H&N Baracudas (10.65) and immediately found pellets mag or pellet seating jamming often. Mag seems to seat fine only when cocking is there the issue. Wiggling the cocking lever at the same time as the mag can fix the issue, but sometimes I need to pull mag shaft and cocking back and wiggle the mag to get it out then re-fit. This is recurring on each mag. I removed and lubed the mag O ring and mag and found zero issues with JSB, but the H&N Baras will load but with extra force required - pre-lube they did not want to load at all. I note all pellets looked and loaded fine when loaded into the mag. Has anyone else found issues with loading high quality pellets of different sizes? I presume my used Cyclone has done a bit of work given previous owners used it for culling, professionally I think...could this indicate a service and maybe replacement of some parts is over-due?

nunga Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Forum Moderator Joined: 08 Mar 2013 Location: Pukekohe Status: Offline Posts: 1010	Post Options Post Reply Quote nunga Report Post Thanks(0) Quote Reply Posted: 15 hours 39 minutes ago at 6:21pm
	It will be the head size causing the problems. I have found with JSB they tend to set the skirt as the head size. If you measure the heads you will find they are all the same size and it is the skirt which is different. H&N the head size is the hard size. I find the H&N are way tighter in the barrel because of this.
	2nd place HP springer - WFTF World Championships 2014

Pauly5 Members Profile Send Private Message Find Members Posts Add to Buddy List Forum Moderator Joined: 10 Mar 2013 Location: Titahi Bay Status: Offline Posts: 1412	Post Options Post Reply Quote Pauly5 Report Post Thanks(0) Quote Reply Posted: 2 hours 42 minutes ago at 7:18am
	When I had a Cyclone I tried H&N Baracuda and experienced exactly that. Silicon solved the issue. They were very accurate for me too. I was using the Baracuda match.