My DIY pellet trap

OK, here are the construction details of my trap as promised (apologies for the very average draughting work).

Materials List (a lot of this I had laying around the shed)

100x25 sawn pine

12mm plywood

3.0mm aluminium checker plate

C/sunk wood screws

Panduit DS5 duct sealing compound - 2 x 5lb blocks (purchased from Element14 for around $50 each with free freight)

Kevlar sheet (purchased from Aliexpress for around $50 delivered)

The box was constructed from pine sides with ply front and rear panels.  There is a large cutout in the front panel and two small holes in the top of the rear panel to enable me to hang it on the wall.  All of this was screwed together with c/sunk screws, the front panel then being removed for the next step.

The next moves were to cut a couple of scrap pieces of checker plate to size and fasten them in place with tacks placed around the perimeter and then to open the two boxes of duct sealant and split them along their length.  The four pieces were then laid onto the alloy and firmly pressed down into place working the edges to flatten the material as best I could.  The stuff is very tacky so bonds strongly to the alloy.

The final layer is Kevlar (aramid fibre) sheet.  I thought I'd ordered woven fabric but upon arrival I found that it was mono-directional supported on a plastic backing sheet.  This resulted in some discussion with the supplier and a refund, so I don't have the direct link.  However, I decided to use it anyway and folded the sheet into multiple layers which I then used the wife's sewing machine to secure together.  This has actually worked very well so in good conscience I ended up contacting the store and paying them back.

From memory the sheet was 0.5 x 2.0m, so I ended up with about 6 layers.  Initially I tried stapling it to the timber sides, but the staples just bent over, they couldn't puncture it.  So a few more tacks were used to keep it in place.

After this the front panel was refitted a bottom slot mount for the Coreflute target backing to sit in was fabricated from a couple of pieces of thin timber and a couple of mouse trap mechanisms were repurposed at each top corner.  In hindsight a single trap at the top centre position would be quite adequate and probably easier to use.

While I was at it I made up a couple of pivoting side plates that I can secure to some bolts on each side so the trap can be used free-standing with adjustment if the surface isn't level.  I haven't bothered with dimensions for these as they're not really necessary but can be easily made using the images below as a guide.  I actually fitted the bolts for these before I installed the duct sealant.

The whole lot was then painted with a couple of coats of my favourite PA10 paint (grey on this occasion) and it was ready for use

I currently have it mounted on the wall of my car shed and it's performed very well so far, a huge advance on the rag-filled cardboard box that preceded it!  However, with 10lb of sealant it's no lightweight to lift into position or move. 

Overall, it was certainly worth the effort and the cost of the materials that I had to buy in to make it.  Hopefully others might feel the same and build something similar for themselves.

My Evanix AR6 has a rotary mag just like a revolver.  Pressurised air pushes the pellet out of the mag and through the barrel with some minor leakage from each face of the mag where it fits into the breach.  The mag rotates to the next chamber when the hammer is cocked (if all works as it should!).

Part #3 in the parts diagram below.