crossman 1322 and upgrades as they happen

Well decided to shim out trigger and Sear. Didn't fancy 80km round trip to town.
After much mucking around came up with this solution?

So if ya need a shim in a hurry.... Knock out the pin, smack with hammer, drill center to size, smack with hammer and polish.
if you have a good drill chuck you can hold by pin in drill and file to diameter first

Edited by kruzaroad - 16 Oct 2022 at 7:51am

Oh bugger

J-S what's your preference on probes extended or hollow? Needing to do either on my build at sometime.

breech arrived. Pulled apart to polish trigger and install.
Then this... new one on order. Didn't even put any pressure on it. sigh
back to trigger and cylinder polishing for now.

i didnt know you needed firearms lic to buy suppressors as never been asked for lic,sounds like bit more the total bs in new laws that dont make sense.

I use a stealth .17hmr/.22 suppressor on my cr600w which works a treat and low cost

Sweet barrel and stock arrived from youngs.
Should turn out about the size Im going for.

Stock is clean as, well moulded. Was expecting something would need sanding off. Nope sweet as.
Now need to sort a quick relase pin to hold in place. Screws not that pratical for breaking it down for pack.
Any ideas or sujestions would be appresiated.
Barrel not the same finish quality. (At $44 I didnt expect it to be)
Threw it on a striat edge, not laser strait but not bent,if that makes sence. Residue in barrel (like looking down a .22lr after the first two shots after cleaning) from factory.
One drill hole has a flake metal still in it. Minor damage at one end. Not from transport here was packed well. Factory I guess or enroute to nz.


Will order a noise suppressor then ship it off to gun smith get it threaded and recrowned, bore polished.
Noise suppresser recomendations be appresiated.

cheers. Its preety primitive set up.
Set up may change witj new breach.

the lego is a interesting idea.