My DIY pellet trap

Declan wrote: Nice work. What are the clips you’ve used to hold the paper target in place please?

The metalwork from a couple of cheap mouse traps repurposed!  When I get around to filling all of the collateral pellet damage and repainting the front panel I'll relocate one of them to the top center position and remove the second - two is overkill :)  I used these as they were cheap and I figured they would be less likely to cause ricochet issues than say a pressed steel paper clamp.

The Coreflute sits in a slotted piece of timber at the base.

Thought I should post some basic details of my pellet trap after checking its condition following some alignment shots with my new Wildcat .25 cal tonight.

It's based on the standard duct sealant design you'll find on Youtube with a few differences. 

The sides are sawn pine with 12mm ply front and rear panels.  Inside the rear panel is some 3mm alloy checker plate (as a backstop) with strips of duct seal about 25-30mm thick pressed onto it.

On the front of that I fastened with small nails into the timber sides (staples just bent over) thin Kevlar fabric that I'd purchased from AliExpress, folded into about 10 layers and sewn together with the wife's sewing machine.

To hold the targets I use some scrap Coreflute cut to size and small blobs of Blutack.

The Kevlar is pretty mangled now but even though it's mono-directional it still stops most pellets dead at the 10m range I use it 99% of the time.  I thought they would eventually make their way through the mangled fibres into the sealant and I'm sure many have, but most seem to either fall back or get hung up.  Ive attached some photos of the JSB Heavies I used tonight, the really mangled one was caught in the Kevlar fibres and the other two were one on top of the other deep in the sealant.

Anyway, it works better than I expected so I thought it might be of interest.  If anyone wants a full build guide let me know -  I'm happy to add a more detailed description to this post.