Flub's General Discussion - Hatsan PCP fill probe

Print Page | Close Window

Hatsan PCP fill probe

Printed From: Kiwi Airgunners
Category: General
Forum Name: Flub's General Discussion
Forum Description: General discussion goes in here.
URL: www.kiwiairgunners.co.nz/forum_posts.asp?TID=636
Printed Date: 05 Nov 2025 at 2:19am
Software Version: Web Wiz Forums 10.14 - http://www.webwizforums.com

Topic: Hatsan PCP fill probe

Posted By: Billbobnz
Subject: Hatsan PCP fill probe
Date Posted: 18 Jun 2022 at 3:29am

Morning team,

As mentioned in a couple of posts my Hatsan 125 vortex piston lost its pressure with obvious seal failure. Been waiting on a new piston for 8 months with no word on arrival. I've done my research and there are a few that have refurbished their vortex piston and installed new seals then re pumped back up with a hand pump and fill probe.

Young's wasn't keen on me refurbishing a piston and told me to wait for the new part. I'm keen to give it a go and have a hand pump but does anyone have a spare compatible fill probe I could borrow for a couple of weeks?

Replies:

Posted By: xyon
Date Posted: 18 Jun 2022 at 4:27am

I think Evan Minton has replaced the seals on one. He might be able to help. Or you could get one of these

https://www.customairseals.com/product/gas-ram-hatsan-125-135-patriot-walther/" rel="nofollow - https://www.customairseals.com/product/gas-ram-hatsan-125-135-patriot-walther/

-------------
---
My favourites
springer - Diana 52
PCP - FX Wildcat III

Posted By: Billbobnz
Date Posted: 18 Jun 2022 at 4:56am

Ok will see if I can get hold of him.

I've asked custom air seals but their ram won't fit the vortex version but I could get one and modify to suit if I can.

Posted By: Billbobnz
Date Posted: 18 Jun 2022 at 11:41am

Minty has refurbished one before, only a few O rings and they are good to go.