For sale Hatsan AT 44
Printed From: Kiwi Airgunners
Category: For Sale / Wanted
Forum Name: For Sale. New Zealand members only
Forum Description: Do you have something for sale? Post it in here. New Zealand members only
URL: www.kiwiairgunners.co.nz/forum_posts.asp?TID=600
Printed Date: 23 Nov 2024 at 2:20pm
Software Version: Web Wiz Forums 10.14 - http://www.webwizforums.com
Topic: For sale Hatsan AT 44
Posted By: Pauly5
Subject: For sale Hatsan AT 44
Date Posted: 19 Nov 2021 at 7:53am
If anyone is interested in a handy single shot hunter pcp, I have a Hatsan AT 44 shooting around 20 fpe for sale.
It was the 10 shot mag version, but a previous owner has widened out the loading area to make it a single shot for target shooting purposes. Synthetis stock that has had weights added to even out the hold, and a fitted moderator to tone down the sound. It's not a std threaded end so a little difficult to fit a bigger silencer. Fill probe included, and it holds air, no leaks.
I can add or message photos later if there's interest. Only asking $250, and happy to send through fire arm dealers network (additional $25)
|
Replies:
Posted By: Pauly5
Date Posted: 19 Nov 2021 at 9:48am
|
Meant to say it's .177 cal
|
Posted By: dvlnme
Date Posted: 19 Nov 2021 at 10:33am
|
thats a cheap pcp Paul wont be hard to sort out refitting mag i would think,prob be just a matter of making a block up to fill the gap mate. cheers mike
|
Posted By: Pauly5
Date Posted: 19 Nov 2021 at 12:59pm
|
I have no doubt in your ability Mike. Pity I'm not closer, as I'd show you, and could be a good project, but I don't have the mag either. I'll post pictures in the technical section, and see what you think.
|
Posted By: dvlnme
Date Posted: 24 Nov 2021 at 8:53am
|
hi Paul,can you put up few pics for me,maybe interested in rifle,but have a few questions,is there a mag included,if not can i buy one?do you think i could rebuild to take a mag?can the power level be lowered to around 16fpe?whats the stock fitted?thanx mate cheers mike
|
Posted By: Pauly5
Date Posted: 24 Nov 2021 at 8:55pm
There's no mag included, and all the retaining pins have been taken out, so I would think you'd have to go down the spring loaded Crosman type mag. The previous owner had filed out where the mag sits so he could single load into the breech. The gap is pretty close to 15 mm.
Pretty sure the power can be reduced by hammer spring adjustment.
The stock is synthetic, and still in tidy condition, but a small plate has been used to close up where weight has been added.
Because the mag was taken out, and the mechanics with it, a small plate has been used to strengthen the whole breech.
I'll try add photos in a minute
|
|