Projects

so here is an update. Ive spent the last few days sorting out the TX. the last shoot i had a problem with the cocking arm coming loose out of the spring loaded ball bearing each time you fired the gun. I would take the shot and miss the target completely and when i looked at the gun the cocking leaver would be hanging loose dangling in mid air on closer inspection the arm looks to be too short to engage the bearing properly. I had a look online but couldnt find much so i decided to take to to ron at youngs. he couldnt work out what the problem was either but did notice that the leaver has a lot of play in it compared to a new one off the shelf. It was going to take a couple of days for him to strip it down and investigate but i needed it back for the mods i plan on doing so i took it back. I stripped it down and the only thing that i can see that would be causing the slackness in the arm is the cocking leaver shoe. I have ordered a new one from ron and ill pick it up when it gets in. This does not fix the problem with the gap between the leaver and the bearing tho. So i came up with a fix. I put a little earth magnet on the barrel and taped it on with some black duct tape so you cant see it. The leaver is nice and snug in there now and its not moving around anymore.

So back to the hook. ive changed my mind about the size of it again and im going to make a new standard size one and ill make a stand thingy for it to sit in while im out in the field and ill just leave the case for it in the boot of the car. The mill is working again so ill start on it today.