Pellet sizing

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I bought a pellet sizer recently.
This one...
https://fentonshooting.co.uk/products/fenton-pellet-sizers-precision-cnc-made
Mine is the 4.53 stainless steel jobbie.
My 9015 has a bit of a tight breech, plus the barrel is choked...which you would think would 'size' a pellet as it was fired. But I noticed that my favourite pellet (H&N FTT) took a good 'thumbing' to make it enter the breech. I thought maybe I was bending/damaging the odd skirt or two as I loaded the pellet as generally the H&N shoot fine but the odd flier was a worry.
I measured the skirt and all pellets were over 4.62 diameter...so I had to start somewhere...and bought the 4.53 sizer. It only sizes the skirt, and that's OK for now.
I have done a batch of the H&N FTT pellets, plus some JSB Exact, and Exact Heavy too. The JSB all load nicely in the breech, but I did put some through the sizer too.
The JSB's all went nicely through the sizer with just a whisker of a bright lip around the skirt edge.
The H&N were a mixture. Some pellets dropped in about 1/2 way down the sizer, others would sit up on top of the sizer's tapered entry port. They all took a good shove to move them through (harder material too maybe).  
Will have a shot tomorrow to see if there is any difference between the various sized and unsized pellets.
If nothing else it may help keep the velocity of the pellets more even if they all start out down the barrel at the same diameter.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Grey Kiwi Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: 09 Jan 2022 Location: Richmond Status: Offline Posts: 58	Post Options Post Reply Quote Grey Kiwi Report Post Thanks(0) Quote Reply Topic: Pellet sizing Posted: 4 hours 46 minutes ago at 10:14am
	I bought a pellet sizer recently. This one... https://fentonshooting.co.uk/products/fenton-pellet-sizers-precision-cnc-made Mine is the 4.53 stainless steel jobbie. My 9015 has a bit of a tight breech, plus the barrel is choked...which you would think would 'size' a pellet as it was fired. But I noticed that my favourite pellet (H&N FTT) took a good 'thumbing' to make it enter the breech. I thought maybe I was bending/damaging the odd skirt or two as I loaded the pellet as generally the H&N shoot fine but the odd flier was a worry. I measured the skirt and all pellets were over 4.62 diameter...so I had to start somewhere...and bought the 4.53 sizer. It only sizes the skirt, and that's OK for now. I have done a batch of the H&N FTT pellets, plus some JSB Exact, and Exact Heavy too. The JSB all load nicely in the breech, but I did put some through the sizer too. The JSB's all went nicely through the sizer with just a whisker of a bright lip around the skirt edge. The H&N were a mixture. Some pellets dropped in about 1/2 way down the sizer, others would sit up on top of the sizer's tapered entry port. They all took a good shove to move them through (harder material too maybe). Will have a shot tomorrow to see if there is any difference between the various sized and unsized pellets. If nothing else it may help keep the velocity of the pellets more even if they all start out down the barrel at the same diameter.