The $100 challenge.....

I was looking at the sear thinking of cutting it back so the there was less travel to disingauge.
Polish and graphite.
I think if the trigger is heavy a short sharp fingerovement is better than long fighting resistance one.
Yep Pauly you got skill and gear to alter the trigger. There's a lot of metal on the actual trigger itself, enough to reposition/add pins. Plenty of room on the plastic round thing it slips into as well

Hummm… after seeing the sig daggers (and assuming u can shoot Kruza 😂) and seeing Paulys H&N ftt’s the JSB exacts aren’t looking too bad.
Before doing any more testing I need to put a scope on so I can see what I’m aiming at 😂😂😂

The reason I did test groups before cleaning is so that I have a base line starting point to start from, and also because that’s how 99.5% of these little guns are going to be used, just bought and shot by kids who’s parents don’t know any better, so for me it’s nice to know who it performs out the box.

Looking at Kruzas pic of the “exploded diagram” of the internals… I need to learn the names of all those different parts. Anyone care to put some labels onto the pic so I can start learning? Would be much appreciated 😃

  About as good as the last (and I mean the last!) Gamo I had...

Edited by KiwiTR6 - 26 Aug 2023 at 4:22am

Ten shot group. 10m
Indoors open sight
AA heavy 10.3 gr weighed
Head size 4.51mm measured
Turned out the best pellet I had.
Couldn't tighten sig up enough with docking ring.
Without Flyers 47mm vertical x 43 horizontal.
With Flyers 57mm vertical x 43 horizontal.
Don't see it tighten up much more than that with pellets I have.
Aimpoint splitting bull in half with sight.
Low on that size pellet so no 20m at moment.

20 meter
Outdoors no wind. Everything same as when shot 10m.
Ran 5 over chrono 438/443/447/442/444 fpe.
Muzzle energy 4.4fpe at 442fps x 10.3gr
10m 4fpe 20m 3.6fpe.

These are what I have to improve on.