Barrel length Wanted

Ron Young usually has 22 crosman barrel in vaious lengths quite cheap ,thats where i get most the 22 barrel i use from,nothing wrong with crosman barrels obviously they not up to the walther barrels,but they still good barrels,cant help you myself as dont at present have any that length can give you.

i am waiting on things from that delayed shipment too,spoke to Ron few weeks back he said approx 6 weeks away then,so must be only few weeks now.

me too i have a crosman 357 co2 revolver i am rebuilding and doing a full custom job on that needs a few new bitz for,i have replaced the complete co2 system but need the back plate behind the mag replaced as the small plastic spring has broken off on the origional part,this is in that shipment,went bit over board on this project,removed factory plastic barrel rib and replaced it with a solid alliminium rib with an 11mm dove tail rail etc,reshaped pistol grip and made new set walnut grip panels to suit,repolished all the alloy frame and side plate,lightly sand blasted then repainted with a baked on paint finish,turned out really nice and cant wait to be able to shoot it.

Seconds later I found this

https://www.pyramydair.com/blog/2007/08/bullets-and-pellets-what-gives/

Thanks Mike, I was looking at H&N knockout slugs today in .22 and the actual diameter of these are .217cal which I understand translates directly to 5.5mm and recommend for pcp rifles due to their exact tight fit.

I've got some knowledge to tell my mate now 🤣

Edited by Billbobnz - 03 Jun 2021 at 5:21pm