|
the dreaded rust strikes |
Post Reply 
|
| Author | |
nunga 
Forum Moderator 
Joined: 08 Mar 2013 Location: Pukekohe Status: Offline Posts: 1009 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: the dreaded rust strikesPosted: 30 Sep 2019 at 9:14pm |
|
hello. welcome to the forum.
|
|
|
2nd place HP springer - WFTF World Championships 2014
|
|
 |
|
|
Tallboy
Member 
Joined: 30 Sep 2019 Location: New Zealand Status: Offline Posts: 1 |
Post Options
Thanks(0)
Quote Reply
Posted: 30 Sep 2019 at 8:36pm |
|
Hi Guys,
I'm new here. |
|
|
|
|
Novagun
Groupie 
Joined: 13 Dec 2016 Location: Wellington Status: Offline Posts: 62 |
Post Options
Thanks(0)
Quote Reply
Posted: 13 Aug 2017 at 9:19am |
|
Never had a rust problem with my airguns. Just rub them down after use with the 3 in 1 oily rag. The occasional miss doesn't matter as long as they wiped down regularly.
I find the best solution for rust on machinery is frequent use and ventilation. Oil on woodworking machinery can mess up a nice piece of timber. Can't keep the moisture out of the air and it has been wet this winter.
|
|
|
|
|
dvlnme
Senior Member 
Joined: 30 May 2017 Location: taranaki Status: Offline Posts: 519 |
Post Options
Thanks(0)
Quote Reply
Posted: 10 Jul 2017 at 12:02pm |
|
Forgot bout that stuff,thanx mate
Cheers Mike
|
|
|
|
|
nunga
Forum Moderator
Joined: 08 Mar 2013 Location: Pukekohe Status: Offline Posts: 1009 |
Post Options
Thanks(0)
Quote Reply
Posted: 06 Jul 2017 at 6:58pm |
|
I would get get some damprid for your safe.
https://www.mitre10.co.nz/shop/search?q=Damprid&categorySelected=Entire+site |
|
|
2nd place HP springer - WFTF World Championships 2014
|
|
|
|
|
dvlnme
Senior Member
Joined: 30 May 2017 Location: taranaki Status: Offline Posts: 519 |
Post Options
Thanks(0)
Quote Reply
Posted: 06 Jul 2017 at 7:47am |
|
Due to my partner being in hospital over last couple weeks hadnt been in workshop for some time,
mustve forgotten to do my usual spray of wd40 over my machinery n we had quite bit wet weather n damp in the air inside workshop did its thing eh!!every exposed surface on lathe n mill covered fine layer rust,bugger it,checked gunsafe n my working guns that dont get surface oiled in same bloody condition,guna have get a heater for inside safe i think,anyone know where to get these gunsafe heaters,seen them advertised somewhere,just cant remember where. Cant do much bout damp air in workshop,just got remember to keep everything oiled eh!!now guna have spend quite few hours cleaning up my machinery i guess,the price not paying attention,so lesson learned eh!!. Cheers Mike
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options