Kiwi Airgunners Homepage
Forum Home Forum Home > General > Flub's General Discussion
  New Posts New Posts RSS Feed - The $100 challenge.....
  FAQ FAQ  Forum Search   Register Register  Login Login

The $100 challenge.....

 Post Reply Post Reply Page  <1 2223242526 32>
Author
Message Reverse Sort Order
Billbobnz View Drop Down
Senior Member
Senior Member
Avatar

Joined: 13 Jun 2020
Location: Ashburton
Status: Offline
Posts: 867
Post Options Post Options   Thanks (0) Thanks(0)   Quote Billbobnz Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 1:22pm
I've noticed that the breech hasn't been machined to 90° so the barrel is sloping down slightly, which means the breech isn't locking properly once cocked. A slight bump and it unlatches which is probably why I am getting the two groupings in the 1 gathering... Breech isn't exactly tight either. I'll disassemble and start the cleaning and will take the barrel into work on Monday to mill the breech
Back to Top
Billbobnz View Drop Down
Senior Member
Senior Member
Avatar

Joined: 13 Jun 2020
Location: Ashburton
Status: Offline
Posts: 867
Post Options Post Options   Thanks (0) Thanks(0)   Quote Billbobnz Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 12:08pm
10 shot group at 10m, Air chief Target Flat tips with Discovery VT-R scope



Back to Top
kruzaroad View Drop Down
Senior Member
Senior Member
Avatar

Joined: 02 Jul 2022
Location: Hastings 4 now
Status: Offline
Posts: 2284
Post Options Post Options   Thanks (0) Thanks(0)   Quote kruzaroad Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 11:46am
Ye gods that's barely a clean hole let alone a crown!
Back to Top
kruzaroad View Drop Down
Senior Member
Senior Member
Avatar

Joined: 02 Jul 2022
Location: Hastings 4 now
Status: Offline
Posts: 2284
Post Options Post Options   Thanks (0) Thanks(0)   Quote kruzaroad Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 11:45am
20 meter
Outdoors no wind. Everything same as when shot 10m.
Ran 5 over chrono 438/443/447/442/444 fpe.
Muzzle energy 4.4fpe at 442fps x 10.3gr
10m 4fpe 20m 3.6fpe.

These are what I have to improve on.
Back to Top
Billbobnz View Drop Down
Senior Member
Senior Member
Avatar

Joined: 13 Jun 2020
Location: Ashburton
Status: Offline
Posts: 867
Post Options Post Options   Thanks (0) Thanks(0)   Quote Billbobnz Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 11:44am
Right, this is 10m with using air chief target flat tips. Much better. I've removed the front sight and will get a scope on.



J-S here is a photo of the crown

Back to Top
kruzaroad View Drop Down
Senior Member
Senior Member
Avatar

Joined: 02 Jul 2022
Location: Hastings 4 now
Status: Offline
Posts: 2284
Post Options Post Options   Thanks (0) Thanks(0)   Quote kruzaroad Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 10:52am
Ten shot group. 10m
Indoors open sight
AA heavy 10.3 gr weighed
Head size 4.51mm measured
Turned out the best pellet I had.
Couldn't tighten sig up enough with docking ring.
Without Flyers 47mm vertical x 43 horizontal.
With Flyers 57mm vertical x 43 horizontal.
Don't see it tighten up much more than that with pellets I have.
Aimpoint splitting bull in half with sight.
Low on that size pellet so no 20m at moment.
Back to Top
Billbobnz View Drop Down
Senior Member
Senior Member
Avatar

Joined: 13 Jun 2020
Location: Ashburton
Status: Offline
Posts: 867
Post Options Post Options   Thanks (0) Thanks(0)   Quote Billbobnz Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 9:30am
Woooooo that's incredible particularly with high quality pellets!

It's like the gun is coughing them out.

Pauly5 I'm wondering with your bent barrel is the steel not that very hard? I've got a carbon tube that will slip over which I will see if it stiffens up and helps with accuracy

Edited by Billbobnz - 25 Aug 2023 at 9:31am
Back to Top
KiwiTR6 View Drop Down
Senior Member
Senior Member


Joined: 03 Nov 2022
Location: Stratford
Status: Offline
Posts: 282
Post Options Post Options   Thanks (0) Thanks(0)   Quote KiwiTR6 Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 9:21am
LOLLOL  About as good as the last (and I mean the last!) Gamo I had...

Edited by KiwiTR6 - 25 Aug 2023 at 9:22am
FX Wildcat MK111 BT Sniper .25
FX Dreamline Classic .22
Diana Outlaw .22
Cometa Fenix 400 .177
Weihrauch HW50 .177
Crosman 2240 PCP Custom .22
Crosman 2250 PCP Custom .22
Brocock Grand Prix .22
Back to Top
kruzaroad View Drop Down
Senior Member
Senior Member
Avatar

Joined: 02 Jul 2022
Location: Hastings 4 now
Status: Offline
Posts: 2284
Post Options Post Options   Thanks (0) Thanks(0)   Quote kruzaroad Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 9:11am
Same target 100 rounds approx.
Gun/ aim point/ pellet same.
Back to Top
RangerPete View Drop Down
Senior Member
Senior Member
Avatar

Joined: 18 Apr 2023
Location: Cambridge.
Status: Offline
Posts: 884
Post Options Post Options   Thanks (0) Thanks(0)   Quote RangerPete Quote  Post ReplyReply Direct Link To This Post Posted: 25 Aug 2023 at 8:14am
Hummm… after seeing the sig daggers (and assuming u can shoot Kruza 😂) and seeing Paulys H&N ftt’s the JSB exacts aren’t looking too bad.
Before doing any more testing I need to put a scope on so I can see what I’m aiming at 😂😂😂

The reason I did test groups before cleaning is so that I have a base line starting point to start from, and also because that’s how 99.5% of these little guns are going to be used, just bought and shot by kids who’s parents don’t know any better, so for me it’s nice to know who it performs out the box.

Looking at Kruzas pic of the “exploded diagram” of the internals… I need to learn the names of all those different parts. Anyone care to put some labels onto the pic so I can start learning? Would be much appreciated 😃
Walk quietly, but carry a big stick.
Back to Top
 Post Reply Post Reply Page  <1 2223242526 32>
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.14
Copyright ©2001-2012 Web Wiz Ltd.

This page was generated in 0.176 seconds.