Crosman 2250B

These models have been around for years with a worldwide following and seems to turnover well when stores have them in stock.

This is how it begins, if you are paying more than NZ$320 new then look again.

The Rat Catcher

Easily transported arriving in a 820 x 190  x 70mm cardboard box.

Powered by CO2 Capsules which are readily available for around $2 to $2.50 each

They are an energy source read the instructions and follow them, if instructions not your thing do not bother with CO2 powered devices.

Inserting pellets, read instructions the rifles firing mechanism pierces the capsule so do not over tighten there is also a recommended lube application of a drop of pelgun or silicon oil on the tip of the capsule and this will be expended on later.

They may be small but if abused they will bite. CO2 is stored as a liquid and releases at pressure.

Never heat, and store with care.

Easy set up especially if plinking with installed fixed sights, not sure if anyone finds the supplied scope usable, they have a certain look but finicky to sight in my opinion.

A common upgrade is fitting a genuine Crosman steel breech $90 and if purchasing from Youngs Airgun Centre or other Agency it would be worth enquiring if it could be installed at the shop. 

Below, plastic breech removed (they work fine) steel breech and Crosman 4x32AO installed.

This does not necessarily improve accuracy so if use is limited to back yard don't bother.

Chronograph Results

These will vary between summer and winter and over the usage of each CO2 capsule, mastering this is part of the skill required to obtain accuracy from your Crosman.

There is advice out there that recommends 5 - 10 seconds between shots to allow metal temperatures to normalise as the CO2 discharge has a chilling affect.

Baseline test November 2022

Ambient temperature 16 degrees

Check them out at https://www.ratbuster.co.uk/

 

I am lucky to have had two modified also requires a new hammer  to be made.

Many options available from overseas including adjustable springs and guide.

Simple spring change, alignment and polish of the original two piece system also gives great results.

Surfaces are cleaned up and tensions set so a very positive latch on the sear when set.

I will go back and have a look both have several thousand pellets through them.

Plinking with an early 2240 yesterday and it tested at 470 fps and 7 ft/lb.