www.kiwiairgunners.co.nz/ This is an XML content feed of; Kiwi Airgunners Forum : Flub's General Discussion : The big move Copyright (c) 2006-2012 Web Wiz Forums - All Rights Reserved. Mon, 18 May 2026 13:48:52 +0000 Mon, 23 Mar 2015 16:01:48 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 10.14 360 www.kiwiairgunners.co.nz/RSS_post_feed.asp?TID=198 www.kiwiairgunners.co.nz/forum_images/logo.jpg www.kiwiairgunners.co.nz/ www.kiwiairgunners.co.nz/forum_posts.asp?TID=198&PID=1286#1286 Author: (pink)MIST
Subject: 198
Posted: 23 Mar 2015 at 4:01pm

good way to spend your downtime at work :)]]> Mon, 23 Mar 2015 16:01:48 +0000 www.kiwiairgunners.co.nz/forum_posts.asp?TID=198&PID=1286#1286 www.kiwiairgunners.co.nz/forum_posts.asp?TID=198&PID=1284#1284 Author: nunga
Subject: 198
Posted: 23 Mar 2015 at 10:48am

Well i had to move the lathe to a new spot as i didnt have enough space to work properly. So i had to make a new bench to house it. The plus is i can use the old bench as a work bench so all good.

SO i made the new bench and sat the lathe on top. All i have to do now is sort out the lighting, Make room for the parts washer ultra sonic cleaner and bench grinder and im good to go.








]]> Mon, 23 Mar 2015 10:48:02 +0000 www.kiwiairgunners.co.nz/forum_posts.asp?TID=198&PID=1284#1284 www.kiwiairgunners.co.nz/forum_posts.asp?TID=198&PID=1282#1282 Author: nunga
Subject: 198
Posted: 20 Mar 2015 at 6:27am

Well i have started moving all my gear out of the garage at home into my newly build workshop at my shop. From there i can really start to pump out the gear and start to push my products and services.



As you can see the mill is in place with my belt sander and there is some good bench space to work off.





This is the spot where the lathe is going which i "should" be moving in tonight. I had to make a custom trolly to take the 620lb weight of the lathe to move it around to get it into position. I was going to use a engine hoist but i can fit to through the door.

Im going to use a chain block to lift it onto the trolly which is on the trailer, transport to the shop and then unload it with the loading ramps i have for the trailer. then it just a matter of pushing it to the spot and use the chain block to lift it on the nice new stand i have made for it.

]]> Fri, 20 Mar 2015 06:27:21 +0000 www.kiwiairgunners.co.nz/forum_posts.asp?TID=198&PID=1282#1282